| |
INK
LEVEL RESET FOR #56
- ALSO WORKS AS AN ALTERNATE FOR 57.
Alternate method |
| |
If you currently use the following HP ink jet cartridges:
#56 C6656
this will allow you to reset the ID system & Ink Level
Indicator built into the printer.
RESETTING
1. Turn your computer OFF & then remove cartridge
from printer.
3. Place a piece of tape over the top left contact as shown
in BLUE on the picture to the right.
4. Turn on computer. Printer will automatically print test
page.
5. Remove cartridge from printer.
6. Place a piece of tape over top right contact as shown
in RED on the picture to the right.
7. Return cartridge to printer. Printer will go through
a series of tests. Which will be quite audible.
9. Remove cartridge from printer.
10. Place a piece of tape over the two contacts on the right
side of the cartridge as shown in GREEN on the picture to
the right.
11. Return cartridge to printer. Printer will run additional
tests and be quite audible.*
12. Remove cartridge from printer & remove all tape
from cartridge.
13. Reinstall cartridge.*
14. Turn printer off. Wait for 20 seconds and turn the printer
back on.
Ink level should now read full.
*
If you check your ink levels at this point you will receive
a “printer busy message”
|
|
