| |
| INK
LEVEL RESET FOR #56 & #58 |
| |
If you currently use the following HP ink jet cartridges:
#56 C6656
#58 C6658
this will allow you to reset the ID system & Ink Level
Indicator built into the printer.
RESETTING
1. Remove cartridge from your printer.
2. Place a piece of tape over the top left contact as shown
in red on the picture to the right.
3. With the tape covering the contact place cartridge back
into printer.
4. The printer will perform and alignment page.
5. Once an alignment page has been printed remove cartridge
from printer.
6. Place a piece of tape over the second contact shown in
red.
7. Place cartridge into printer with both pieces of tape.
(One covering the first contact and one cover the second
contact.)
8. Printer will print another alignment page.
9. Once the second alignment page has been printed remove
cartridge from printer.
10. Remove tape pieces from cartridge contacts
Make sure there is no residual adhesive
on cartridge contacts.
11. Place cartridge into printer. Cartridge should now read
full.
Additional Notes:
As stated above it is very important that there is no residual
adesive on the cartridge contact point. This will make reading
the cartridge difficult.
WHEN YOU ARE DONE HERE...
HOW
TO RESET THE HP #56 (C6656) & HP #58 (C6658)
ALTERNATE
RESET FOR #56
ROTATING
CARTRIDGES
|
|
